01-09-2013, 09:44 PM
Programms u need:
Cheat Engine or any other tool like this.
i use now cheat engine bc the most ppl here use it.
I will show it on the mystery PVP client.
the easyest to find is the _pNetwork open cheat engine and select ur process klick on
"Add Address Manually" and type in _pnetwork and ok
now we see down the Address this address we will use
(if process is named.exe jsut put the name in without .exe)
Next step we search the zone offset
stay in juno with the character and use as search value 0, scan type Exact value, value type 4 bates
Klick on First Scan. (it will find alot)
after scan is done go to teleporter and we teleport to Merac.
Now change the Value to 7 caus Merac is ZoneID 7 and klick Next Scan
after scan again done go to the teleporter and teleport back to Juno and change value to 0 and klick Next scan again. Do this till you have 3 left in the list,
now we have 3 left and it should look like this
double klick allthat they are added down to the list
now righ klick all 3 each and klick "Find out What writes to this address", you should have 3 windows open now that are empty.
next step is go teleporter and Teleport again.
after the teleport you should see somethign like this:
the one where stand GameMP.dll+XXXX and engine.g_slZone we can close
the last one is our offset in "mov[eax+0010A94C].ecx" ( offset = 0010A94C ) so we can add this one to.
Now we going to find X Z and H positon.
Klick in Cheat engine "new Scan"
value the X positon u standing on by me its 595, scan type Exact Value, Value Type Float
and klick first scan ( best is u do this where no one ist around )
now move a bit and change the value to where u standing and klick next scan do this again till you have around 3 addresses left in the list
http://img850.imageshack.us/img850/7961/...3b9136.png
double klick all again and do waht we did already with finding the zone offse,tright klick on all "Find out What writes to this address",
2
there we can see already what our offset is "mov[ecx+0010A958].eax" offset 10A958 is waht we need
add it to the config...
to get the pos. Z you could do the same but easyer is to count 4 up then you get the pos. H ( 10A95C ) and agian 4 ( 10A960 ) up you get the pos. Z
add it to the tool and save
2
and see its working.
the way of counting is ( 0 1 2 3 4 5 6 7 8 9 A B C D E F ) and not ( 0 1 2 3 4 5 6 7 8 9 )
hope this did help