how to increase numer of mobs at Procyon

[fantasymerlin]

I have seen that at the Procyon Shrine not enough mobs.

 

How can I raise the number of the mobs at this place because only one or 2 mobs at a room isn´t enough.

 

Thank you very much

[peter3301]

_data -> t_npc_regen -> you need to set every spawn, if you need more mobs, you can copy the exist spawns for the doungen or you set it 'manual'.

[fantasymerlin]

Ok you mean in this format (very small showing)

 

index      zone      npc idx      pos

120078    6             144        27,938 (original) ...

120500    6             144        27,960 (my own) ... (all after this of course too)

 

Is every row only one mob or are there a for one row for example a packet of mobs? I think its only one? Or I set this with a_total_num at the end of the row? What means a "-1" in this field?

 

npx idx is the number of my mob which i want to spawn. This I find in my t_npc table right?

 

Then I had create a new spawn point of a mob at a new location right?
 

[peter3301]

I only know you can use single spawns, like one row are one mob.

the npx idx is the mob id yes.

Yes but you can set the spawn near the other. You have two mob at the same location.

[fantasymerlin]

Super. This is easy. Then I can only copy the row with my mob and only change the coordinates x y etc and restart the gameserver. I can try with a_total_number, too and then I can test if there are one or two mobs with a single row.

 

Thank You very much.

 

I will test it later.

[camaro2683]

@fantasymerlin you can also use this tool  2

[fantasymerlin]

This tool is for ep3. I went to the procyon shrine but don't Work for ep4. I will Test later if it is only at This place or everywhere.

 

The tool don't See where I am if I Inside procyon. It seems that the tool don't Work correctly.

 

At Procyon I think I have to so manually.